Floor Installation - Dantherm Rcv320 P1 Benutzerhandbuch

Floor installation

40
4. Ensure that the unit is horizontally aligned. The top edge of the unit must be in a
horizontal position or slightly inclined from the wall. Note: The top edge must not be
inclined towards the wall as this may cause moisture damages.
Fig. 42: Checking the alignment
INFORMATION
The unit can transmit vibrations to the surrounding components in non-insulated floor
constructions, e.g. in attics. For non-insulated floor constructions, the unit must be placed on
a sound-insulating substructure.
1. Create a wooden substructure with an insulation of at least 50 mm thickness for non-
insulated floor constructions. Ensure that the substructure is aligned horizontally. Note:
Make sure that the substructure can support the weight of the unit.
750 mm
Fig. 43: Creating a wooden substructure
2. Fit the Dantherm-approved floor brackets (accessories) to the unit to establish the
required distance from the unit to the floor. Information: Dantherm accepts no liability
for floor brackets from other manufacturers. Using other floor mounts is at your own risk.
INSTALLATION AND SERVICE MANUAL FOR PROFESSIONALS
850 mm
100 mm
Installation: Assembly