Ego Power+ ZERO TURN ZT5200E-L Bedienungsanleitung Seite 30

EN
PROBLEM
The mower fails to start the
blades when the PTO switch
is engaged.
PTO Switch icon blinks
The blades stop working
during grass cutting.
The beeping indicator
continues sounding.
30
ZERO TURN RIDE-ON MOWER — ZT5200E-L
CAUSE
◾
The combined Ah of the inserted
batteries does not meet the
requirement.
◾
The PTO switch is not pushed down
when the mower is stopped last
time.
◾
The mower is overloaded at the
moment the blades starting, resulting
in motor self-protection.
◾
Under extreme cold weather,
the blade motor may not start
successfully due to the low
temperature protection.
◾
The blade interferes with the
deformed mower deck.
◾
The mower is overloaded.
◾
The mower deck is clogged with
grass and debris.
◾
The mower is overheated.
◾
The battery pack(s) in the mower's
battery compartment is overheated,
resulting in combined Ah rating of
all inserted batteries to not meet the
requirement.
◾
The mower is in Limp-Home mode.
◾
The mower is hit a foreign object,
resulting in motor self-protection.
◾
The mower is in Limp-Home mode
and the blades are not turned off.
◾
The mower stops driving on a slope
and the operator opens the steering
levers and is off the seat without
setting the parking brake pedal at
the braking position.
SOLUTION
◾
In order to start this mower, use enough EGO batteries following
the instructions in section "CHARGING" in this manual.
◾
Push the PTO switch downward and restart the mower's blades.
◾
Start the mower grass cutting in lower blade speed first and until
the blades are getting successes rotation, do not accelerate the
blade speed as needed.
◾
Always store the mower and battery in warm environment. Restart
the mower when it is warmed up. Please do not make repeated
attempts under extreme cold weather which may damage the
machine.
◾
Contact a qualified service technician for repair.
◾
Raise the deck cutting height or slow down the driving speed to
reduce the load of the mower.
◾
Clean the mower deck and make certain that the blades have
freedom of movement.
◾
Reduce the load of the mower, by raising the deck cutting height
or slowing down the blade/driving speed and allow the mower to
cool.
1. If the combined battery Ah rating does not meet the requirement,
the mower will not work until more battery packs are inserted
into the vacant battery components. Once the overheated battery
returns to normal temperature, it will join in powering the mower
immediately.
2. Reduce the load of the mower by raising the deck cutting height
or slowing down the mowing when resuming operation.
◾
When the mower is in Limp-Home mode, the blades are
automatically switched into low rotation speed without grass
cutting. The operator should stop working and go to the battery
charging area as soon as possible.
◾
Push the PTO switch downward and restart the mower blades.
◾
Push the PTO switch down to disengage the deck blades. The
beeping indicator will stop sounding when the blade stops.
◾
Set the parking brake pedal in the braking position before leaving
the mower on the slope.