Werock Rocksmart RSC600 Bedienungsanleitung Seite 96

Intel® TCC mode
Use this item to enable or disable Intel® TCC mode. When set as [Enable], this will modify system
settings to improve real-time performance and display the full list of settings and their current state are
displayed below when Intel® TCC mode is enabled.
The optional settings: [Disabled]; [Enabled].
Intel® TCC Authentication
Use this item to enable or disable Authentication of Intel® TCC configuration date.
The optional settings: [Disabled]; [Enabled].
When Intel® TCC mode set as [Disabled], the following sub-items shall appear:
IO Fabric Low Latency
Use this item to enable or disable IO Fabric Low Latency. This will turn off some power management in the
PCH IO fabrics. This option provides the most aggressive IO Fabric performance setting S3 state is NOT
supported. The optional settings: [Disabled]; [Enabled].
GT CLOS
Use this item to enable or disable Graphics Technology(GT) Class of Service. Enable will reduce Gfx LLC
allocation to minimize impact of Gfx workload on LLC. The optional settings: [Disabled]; [Enabled].
Trusted Computing
Press [Enter] to view current status information, or make further settings in the following sub-items:
TPM 2.0 Device Found
Security Device Support
Use this item to enable or disable BIOS support for security device. O.S. will not show Security Device.
TCG EFI protocol and INT1A interface will not be available.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], user can make further settings in the following items:
Active PCR Banks
Available PCR Banks
SHA-1 PCR Bank
Use this item to enable or disable SHA-1 PCR Bank.
The optional settings: [Disabled]; [Enabled].
SHA256 PCR Bank
Use this item to enable or disable SHA256 PCR Bank.
The optional settings: [Disabled]; [Enabled].
SHA384 PCR Bank
Use this item to enable or disable SHA384 PCR Bank.
The optional settings: [Disabled]; [Enabled].
When PTT configuration > TPM Device Selection set as [PTT] , user can make
Pending operation
Use this item to schedule an Operation for the Security Device.
*Note: Your Computer will reboot during restart in order to change State of Security Device.
The optional settings: [None]; [TPM Clear].
ACPI Settings
Press [Enter] to make settings for the following sub-items:
Rocksmart RSC600 User Manual
96 / 110