Pc Health Status; Usb Configuration - Werock Rocksmart Rsc600 Bedienungsanleitung

Flow Control EMS
Flow control can prevent data loss from buffer overflow. When sending data, if the receiving buffers are full, a
"stop" signal can be sent to stop the data flow. Once the buffers are empty, a "start" signal can be sent to
re-start the flow. Hardware flow control uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff]. Data Bits EMS
The default setting is: [8].
*This item may or may not show up, depending on different configuration. Parity EMS
The default setting is: [None].
*This item may or may not show up, depending on different configuration. Stop Bits EMS
The default setting is: [1].
*This item may or may not show up, depending on different configuration.

PC Health Status

Press [Enter] to view current hardware health status, make further settings in ' SmartFAN Configuration'.
SmartFAN Configuration CPUFAN Smart Mode
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN Full-Speed Temperature
Use this item to set CPUFAN full speed temperature. Fan will run at full speed when above this pre-set
temperature.
CPUFAN Full-Speed Duty
Use this item to set CPUFAN full-speed duty. Fan will run at full speed when above this pre-set duty.
CPUFAN Idle-Speed Temperature
Use this item to set CPUFAN idle speed temperature. Fan will run at idle speed when below this pre-set
temperature.
CPUFAN Idle-Speed Duty
Use this item to set CPUFAN idle speed duty. Fan will run at idle speed when below this pre-set duty

USB Configuration

Press [Enter] to make settings for the following sub-items:
USB Configuration
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI ownership change should be
claimed by XHCI driver.
The optional settings: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB mass storage driver support.
The optional settings: [Disabled]; [Enabled].
time-outs:
USB transfer time-out
Use this item to set the time-out value for Control, Bulk, and Interrupt transfers. The optional settings: [1
sec]; [5 sec]; [10 sec]; [20 sec].
Rocksmart RSC600 User Manual
USB hardware delays and
53 / 110