Werock Rocksmart RSC600 Bedienungsanleitung Seite 101

Rocksmart RSC600 User Manual
temperature.
CPUFAN Idle-Speed Duty
Use this item to set CPUFAN idle speed duty. Fan will run at idle speed when below this pre-set duty
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI ownership change should be
claimed by XHCI driver.
The optional settings: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to enable or disable USB mass storage driver support.
The optional settings: [Disabled]; [Enabled]. USB hardware delays and
time-outs:
USB transfer time-out
Use this item to set the time-out value for Control, Bulk, and Interrupt transfers. The optional settings: [1
sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage device Start Unit command time-out.
The optional settings: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports itself to the host controller.
'Auto' uses default value: for a root port it is 100 ms, for a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select [Manual] you can set value for the following sub-item:
'Device power-up delay in seconds', the delay range in from 1 to 40 seconds, in one second
increments.
Network Stack Configuration
Press [Enter] to go to 'Network Stack' screen to make further settings.
Network Stack
Use this item to enable or disable UEFI Network Stack.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
IPv4 PXE Support
Use this item to enable IPv4 PXE boot support. When set as [Disabled], IPv4 boot support will not be
available.
The optional settings: [Disabled]; [Enabled].
IPv6 PXE Support
Use this item to enable IPv6 PXE boot support. When set as [Disabled], IPv6 boot support will not be
available.
The optional settings: [Disabled]; [Enabled].
101 / 110