Serial Port Console Redirection - Werock Rocksmart Rsc600 Bedienungsanleitung

Rocksmart RSC600 User Manual
to have all active wake-up functions.
The optional settings: [Disabled]; [Enable].
Case Open Detect
Use this item to detect case has already open or not, show message in POST. When set as [Enabled],
system will detect if COPEN has been short or not (refer to JPCLR jumper setting for Case Open
Detection; if Pin 7&8 of jumper JPCLR are short, system will show Case Open Message during POST).
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
The optional settings: [Disabled]; [Enable].
When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [10] to [255] seconds when 'WatchDog Reset Timer Unit' set as
[Sec]; or in the range of [1] to [255] minutes when 'WatchDog Reset Timer Unit' set as [Min]. WatchDog
Reset Timer Unit
The optional settings: [Sec.]; [Min.].
WatchDog Wake-up Timer
Use this item to enable or disable WDT wake-up function.
The optional settings: [Disabled]; [Enable].
When set as [Enabled], the following sub-items shall appear:
WatchDog Wake-up Timer Value
User can select a value in the range of [10] to [4095] seconds when 'WatchDog Reset Timer Unit' set as
[Sec]; or in the range of [1] to [4095] minutes when 'WatchDog Reset Timer Unit' set as [Min]. WatchDog
Wake-up Timer Unit
The optional settings: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power supply. Use needs to
select 'AT or ATX Mode' on MB jumper at first (refer to AT_MODE jumper setting Pin 1&2 of for ATX Mode &
Pin 2&3 of AT Mode Select).

Serial Port Console Redirection

COM1
Console Redirection
Use this item to enable or disable Console Redirection.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], user can make further settings in the following items:
Console Redirection Settings
The settings specify how the host computer and the remote computer (which the user is using) will
exchange data. Both computers should have the same or compatible settings.
Press [Enter] to make settings for the following sub-items.
COM1
Console Redirection Settings
Terminal Type
The optional settings: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
Emulation: [ANSI]: Extended ASCII char set; [VT100]: ASCII char set; [VT100+]: Extends VT100 to
support color, function keys, etc.; [VT-UTF8]:
Uses UTF8 encoding to map Unicode chars onto 1 or more bytes. Bits per second
Use this item to select serial port transmission speed. The speed must be matched on the other side. Long
or noisy lines may require lower speeds. The optional settings: [9600]; [19200]; [38400]; [57600]; [115200].
51 / 110