Werock Rocksmart RSC600 Bedienungsanleitung Seite 100

Rocksmart RSC600 User Manual
Serial Port for Out-of-Band Management/ Windows Emergency Management Services
(EMS) Console Redirection EMS
Use this item to enable or disable Console Redirection.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Console Redirection Settings
The settings specify how the host computer and the remote computer (which the user is using) will
exchange data. Both computers should have the same or compatible settings.
Press [Enter] to make settings for the following items:
Out-of-Band Mgmt Port
Terminal Type EMS
The optional settings: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
[VT-UTF8] is the preferred terminal type for out-of-band management. The next best choice is [VT100+] and
them [VT100]. See above, in Console Redirection Settings page, for more help with Terminal
Type/Emulation.
Bits per second EMS
Use this item to select serial port transmission speed. The speed must be matched on the other side. Long
or noisy lines may require lower speeds.
The optional settings: [9600]; [19200]; [57600]; [115200].
Flow Control EMS
Flow control can prevent data loss from buffer overflow. When sending data, if the receiving buffers are full, a
"stop" signal can be sent to stop the data flow. Once the buffers are empty, a "start" signal can be sent to
re-start the flow. Hardware flow control uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff]. Data Bits EMS
The default setting is: [8].
*This item may or may not show up, depending on different configuration. Parity EMS
The default setting is: [None].
*This item may or may not show up, depending on different configuration. Stop Bits EMS
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
PC Health Status
Press [Enter] to view current hardware health status, make further settings in ' SmartFAN Configuration'.
SmartFAN Configuration CPUFAN Smart Mode
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN Full-Speed Temperature
Use this item to set CPUFAN full speed temperature. Fan will run at full speed when above this pre-set
temperature.
CPUFAN Full-Speed Duty
Use this item to set CPUFAN full-speed duty. Fan will run at full speed when above this pre-set duty.
CPUFAN Idle-Speed Temperature
Use this item to set CPUFAN idle speed temperature. Fan will run at idle speed when below this pre-set
100 / 110