Network Stack Configuration; Nvme Configuration - Werock Rocksmart Rsc600 Bedienungsanleitung

Rocksmart RSC600 User Manual
Device reset time-out
Use this item to set USB mass storage device Start Unit command time-out.
The optional settings: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports itself to the host controller.
'Auto' uses default value: for a root port it is 100 ms, for a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select [Manual] you can set value for the following sub-item:
'Device power-up delay in seconds', the delay range in from 1 to 40 seconds, in one second
increments.

Network Stack Configuration

Press [Enter] to go to 'Network Stack' screen to make further settings.
Network Stack
Use this item to enable or disable UEFI Network Stack.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
IPv4 PXE Support
Use this item to enable IPv4 PXE boot support. When set as [Disabled], IPv4 boot support will not be
available.
The optional settings: [Disabled]; [Enabled].
IPv6 PXE Support
Use this item to enable IPv6 PXE boot support. When set as [Disabled], IPv6 boot support will not be
available.
The optional settings: [Disabled]; [Enabled].
PXE Boot Wait Time
Use this item to set wait time to press [ESC] key to abort the PXE boot.
Use either [+] / [-] or numeric keys to set the value.
Media Detect Count
Use this item to set number of times presence of media will be checked. Use either [+] / [-] or
numeric keys to set the value.

NVMe Configuration

Press [Enter] to view current NVMe Configuration.
*Note: options only when NVME device is available.
Wake-up Function Settings
Press [Enter] to make settings for the following sub-items:
Wake-up System With Fixed Time
Use this item to enable or disable System wake on alarm event.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following items shall appear: Wake-up Hour
Use this item to select 0-23. For example enter 3 for 3am and 15 for 3pm. Wake-up Minute
Use this item to select 0-59.
Wake-up Second
Use this item to select 0-59.
54 / 110