Carl Valentin DPM III XI Kurzanleitung Und Hinweise Zur Produktsicherheit Seite 100

DPM III xi
Angle Adjustment
The installation angle of the printhead is default 26° to the print surface. However, manufacturing tolerances of the printhead
and the mechanics can require another angle.
CAUTION!
Damage of printhead by unequal use!
Higher wastage of ribbon by faster ripping.

Only change the factory settings in exceptional cases.
•
Loosen slightly two Allen head screws (2).
•
Move adjusting part (1) to adjust the angle between printhead and printhead support.
Tighten = decrease angle
Loosen = increase angle
•
Tighten again the Allen head screws (2).
•
Start a print order with approx. three layouts to check the correct unwrinkled ribbon run.
NOTICE!
The slots serve for the position control. Pay attention to a parallel adjustment.
Zero Point Adjustment
100
•
By means of a slider (1) you have the possibility to change the printer
zero point.
•
In case the slider is at the end of its guiding then the maximum print
length is available.
•
If you change the zero point the way from zero point to the print start is
shortened. Moreover you can use the change of zero point to change
the printhead position of the foil which is to be printed.
•
By changing the zero point of printer the print area is more shorten.
English