Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Start-up
6 Start-up
6.1
Pairing
Please read this entire section
before starting the pairing proce-
dure.
First set up your Homematic IP
Access Point using the
Homematic IP app so that you can
use other Homematic IP devices
in the system. For further informa-
tion, please refer to the Ac-
cess Point operating manual.
To integrate the window and door
contact into your system and en-
able it to communicate with other
Homematic IP devices, you must add
the device to your Homematic IP Ac-
cess Point first.
Proceed as follows to add the window
and door contact:
• Open the Homematic IP app on
your smartphone.
• Select "Add device".
• Remove the insulation strip from
the battery compartment (C) of the
window and door contact.
• The pairing mode is active for 3
minutes.
You can manually start the pairing
mode for another 3 minutes by
briefly pressing the system button
(F).
Figure 2
Your device will automatically appear
in the Homematic IP app.
• To confirm, enter the last four dig-
its of the device number (SGTIN) in
your app, or scan the QR code. The
device number can be found on
the sticker supplied in the package
contents or attached to the device.
• Wait until pairing is complete.
• If pairing was successful, the LED
(F) lights up green. The device is
now ready for use.
• If the LED lights up red, please try
again.
• Select the desired solution for your
device.
• In the app, give the device a name
and allocate it to a room.
17
Werbung
