Yashica CONTAX RTS Gebrauchsanweisung Seite 26

FILM LOADING (II)
4. After making sure that the shutter control dial is set at a position
other than the 'AU TO' setting , advance the film unti I the sprocket
teeth properly catch the perforations along both edges of the film.
Then , close and press the back cover until it locks into place.
5. Fold out the film rewind crank-handle and turn it in the direction of
the arrow to take up the fi lm slack .
• When folded , the crank-hand le will rotate freely ; therefore,
make sure it is returned into the compartment above the 'AU TO'
setting.
6. Press the magnetic release and advance the film , alternately,
until the exposure counter registers the figure ' 1'
23
If the white line on the film rewind knob rotates when the film
advance lever is manipulated , it means the film is advancing
properly.
CAUTION
Avoid keeping th e LED display pushbutton depressed when
advancing th e film . Particularly in case the Real Time Winder
is in use, make it a rule to keep your finger off the LED display
pushbutton when making exposure .