HT Instruments HT10 Bedienungsanleitung Seite 35

5.7. CONTINUITY TEST
Before performing the continuity test, remove power from
the circuit under test and discharge all capacitors
1. Perform the preliminary Autotest function (see § 5.1)
2. Connect the L1 and L2 probes to the object under test (see Fig.
9)
3. Continuity test is active for resistance
automatically on with LED "
and the buzzer sounds continuously indicating a positive test
4. The meter automatically turns on when the two probes are
separated from the measured object
5. Press the / key to activate/deactivate the white LED torch
5.8. RESISTANCE MEASUREMENT
Before taking any in circuit resistance measurement,
remove power from the circuit to be tested and discharge
all the capacitors
1. Perform the preliminary Autotest function (see § 5.1)
2. Press and hold the
"OL" and "" symbols are displayed
3. Connect the L1 and L2 probes to the object under test (see Fig.
10). The resistance value is shown at display
4. Press the H/ key to activate/deactivate the function HOLD at
display. Press
activate/deactivate the display backlight
5. Press the / key to activate/deactivate the white LED torch
6. Press and hold the
6. MAINTENANCE
35
CAUTION
", the "Con" message is displayed
CAUTION
/ key to switch on the instrument The
and hold the H/
/ key to switch off the instrument
HT10
<400k. The meter turns
key in order to