General Description; Preparation For Use; Initial Checks; Power Supply - Ht Instruments Ht10 Bedienungsanleitung

2. GENERAL DESCRIPTION

The instrument performs the below measurements:
• DC Voltage with 2-wire method
• AC Voltage with 2-wire method
• AC Voltage with 1-wire method (polarity detection)
• AC Voltage measurement with low impedance value
• Phase sequence indication
• Resistance measurement
• Continuity test with buzzer
The measurement result is displayed with indication of the
measuring unit both in numerical mode and on the LCD display. A
white pointer LED is also available in order to correctly perform the
tests even in poorly lit environments

3. PREPARATION FOR USE

3.1. INITIAL CHECKS

The instrument has been checked from a mechanical and electrical
point of view before shipment. Every care has been taken to make
sure that the instrument reaches you in perfect conditions. However,
it's advisable to make a rapid check to detect any damage which
may have occurred in transit. Should this be the case, enter
immediately the usual claims with the carrier. Make sure that all the
accessories listed in § 7.3.1 are contained in the package. In case of
discrepancies contact Your dealer. In case of returning of the tester
please keep to the instructions given in § 8

3.2. POWER SUPPLY

The instrument is powered by 2x1.5V alkaline batteries type AAA
LR03. When batteries are low, a low battery indication "
displayed. To replace batteries please follow the instructions of § 6.2
3.3. STORAGE
After a period of storage under extreme environmental conditions
exceeding the limits mentioned in § 7.2 let the instrument come
back to normal measuring conditions before using it.
27
HT10
" is