Werbung
EN
Cleaning
Adjust spray gun inlet pressure
If the required spray gun inlet pressure is
Î
not achieved, increase the pressure on the
compressed air network (too high pressure
leads to high trigger forces and can cause
errors in the painting result).
Adjust the material flow
NOTICE
With the material flow control fully opened, the
wear of the fluid tip and paint needle is reduced
to a minimum. Please select the correct nozzle
size depending on the material to be applied
and the required application speed.
Painting
Maintain spraying distance, see chapter Tech-
Î
nical data.
98
CLEANING
WARNING
Serious risk of injury from com-
pressed air.
Î Do not bring the spray gun into
potentially explosive atmospheres
of ex-zone 0.
Î Prior to maintenance, disconnect
spray gun from the compressed air
circuit.
Î Disassemble and assemble parts
with extreme care.
Werbung
