General; Safety; Requirements - Fronius Rc Bar Ijob Bedienungsanleitung

General

Safety

Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
▶
▶
Danger due to welding processes starting unintentionally. Once the remote con-
trol has been connected, the welding process can be started using the welding
torch or the remote control.
Could result in serious personal injury and damage to property.
▶
Danger from welding operation (blinding hazard, flying sparks, harmful welding
fume, noise, etc.)
Personal injury may result.
▶
▶
▶
▶
Danger due to emerging wire electrode.
Personal injury may result.
▶
▶
▶
▶

Requirements

The RC Bar iJob /TMC* remote control can be used with the following welding
machines:
-
-
The RC Bar Up/Down /TMC remote control can be used with the following wel-
ding machines:
12
WARNING!
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
Read and understand this document in full.
Read and understand all safety rules and user documentation for this equip-
ment and all system components.
WARNING!
Ensure that the welding process is only started intentionally.
WARNING!
Keep unauthorized people away during the operation of the devices and du-
ring the welding process.
Inform people in the vicinity about all the dangers of the welding operation.
Provide suitable protective equipment.
Construct suitable protective walls and curtains.
CAUTION!
Hold the welding torch so that the tip of the welding torch points away from
the face and body.
Wear suitable protective goggles.
Do not point the welding torch at people.
Ensure that the wire electrode can only intentionally make contact with
electrically conductive objects.
TPS 320i - 600i with a WF 25i/30i wirefeeder and integrated optional con-
nection OPT/WF TMC
All welding machines in the iWave series