Silvercrest SSWR C2 Bedienungsanleitung Seite 17

Use a dry lint-free cloth or
cotton swab to clean the
contacts on the battery/
rechargeable battery and
in the battery compartment
before inserting!
Remove exhausted batteries/
rechargeable batteries from
the product immediately.
This product features a built-in
rechargeable battery which
cannot be replaced by the
user. The rechargeable battery
must be removed or replaced
by the manufacturer or their
service centre or a similarly
qualified person to avoid
hazards. When disposing
of the product, you must
indicate this product contains a
rechargeable battery.
Clean the product and its
accessories (see "Cleaning
and care").
˜ Initial use
˜ Charging the product
m CAUTION! Position the charging dock
out of direct sunlight.
NOTES:
Fully charge the product before using it for
o
the first time. It takes approx. 4–6 hours to
charge.
Keep 1 m from the left/right and 2 m from
o
the front of the charging dock
other objects (Fig. C).
o
o
o
o
o
1. Connect the DC plug of the mains
2. Connect the mains adapter
3. Place the charging dock
4. Switching on:
5. Place the product on the charging dock
6. Once charging is completed, the indicator
[ 5 ]
˜ Attaching the side brushes
clear of
[ 5 ]
Keep 15 cm from the top of the charging
dock clear of mirrors or other highly
[ 5 ]
reflective objects. If necessary, cover any
mirrors or highly reflective objects.
The product sometimes corrects its position in
the charging dock .
[ 5 ]
Try not to change the position of the
charging dock . A fixed position makes it
[ 5 ]
easier for the product to find its way back to
the charging dock.
Charge the product when the indicator lights
on the button and the
[ 2 ]
flash white.
Before charging: Remove the water tank
from the product (see "Using the mop
function").
adapter to the charging dock
[ ]
outlet. The indicator light
wall.
–
Set the on/off switch
the product to I position (on).
–
Press and hold
[ 2 ]
indicator light on the
1 minute and then goes off.
(Fig. D).
Align the charging contacts
of the product with the charging contacts
on the charging dock.
The indicator lights on the
and the button
3 ] [
breathing effect.
lights on the button
button go off.
[ 3 ]
NOTE: When attaching the side
brushes , make sure that the markings
[ ] [ ]
L and R on the bottom of the product and on
the side brushes match.
button
[ 3 ]
[ ]
.
[ 5 ]
to a socket-
[ ]
lights up.
6 ] [
flush against a
5 ] [
at the bottom of
[ ]
for 3 seconds. The
button flashes for
[ 5 ]
at the bottom
[ ]
7 ] [
button
2 ] [
light up white with a
and the
2 ] [
GB/IE/NI 17