SCHUNK ERT 12 Originalbetriebsanleitung Seite 85

6.2 Product is having control difficulties.
Possible cause
Driver controller is not optimally
adjusted.
6.3 Product is vibrating.
Possible cause
Load inertia is too high.
Drive controller is not optimally
adjusted.
6.4 Bearing noise
Possible cause
Incorrect assembly.
Bearing defective due to overload.
08.00 | ERT 12 / 50 / 100 / 300 | Translation of Original Operating Manual | de en | GAS0406665
Corrective action
Check the settings (direction of rotation of motor and
encoder direction of counting).
Corrective action
Check the dimensioning.
Reduce the load.
Check the settings on the drive controller.
Check the settings on the drive controller.
Corrective action
Check that the mounting surface is flat.
} 5.2.1 [/ 76]
Replace component or send it to SCHUNK for repair.
Troubleshooting
85