Parkside PWSA 12 C2 Bedienungsanleitung Seite 19

The charge level of the battery is indicated by
o
the LEDs when the product is in operation.
Push the pressure point on the on/off switch
downwards and slide the on/off switch
forwards.
˜ Troubleshooting
Problem
The product does
not start.
The grinding tool
does not move
although the
engine is running.
The engine is
slower and stops.
The grinding disc
does not rotate
smoothly, abnormal
noises can be
heard.
˜ Cleaning and maintenance
m WARNING!
Switch the product off and remove
the battery pack before replacing
attachments, cleaning and when not in
use.
5 ] [
Possible cause
The battery is discharged.
[ 9 ]
The battery is not inserted
[ 9 ]
in the product.
The on/off switch is
5 ] [
damaged.
The product is damaged.
The clamping screw
[ 3 ]
loose.
Workpiece, remaining
workpieces or remaining
grinding tools block the drive.
The product is overloaded
through the workpiece.
The clamping screw
3 ] [
loose.
The cutting/grinding disc is
defective.
LED
red-yellow-green
[ ]
red-yellow
red
Solution
Charge the battery
Insert the battery
Contact the service centre.
is Tighten the clamping screw
changing the cutting/grinding disc").
Remove the blockages.
Reduce the pressure on the grinding tool.
The workpiece is unsuitable.
is Tighten the clamping screw
changing the cutting/grinding disc").
Change the cutting/grinding disc
(see „Installing/changing the cutting/grinding
disc").
m WARNING!
Do not use any cleaning agent or solvent.
u
Chemical substances can etch the plastic
parts of the product.
Never clean the product under running
u
water.
Status
Battery fully charged
Battery half charged
Battery needs to be charged
.
9 ] [
into the product.
9 ] [
(see „Installing/
3 ] [
(see „Installing/
3 ] [
GB 19