Parkside PWSA 12 C2 Bedienungsanleitung Seite 18

5. Press the spindle retaining tab and tighten the
clamping screw using the hex key. Release the
spindle retaining tab.
˜ Inserting/removing the
rechargeable battery
Inserting the battery: Push the battery
o
along the guide rails into the product. The
battery clicks into place.
Removing the battery: Press the release
o
button on the battery and pull the battery
8 ] [
out.
˜ Operation
m WARNING!
Wear protective gloves when changing
the tool so as to avoid injuries from cuts.
m WARNING!
Switch the product off and remove
the battery pack before replacing
attachments, cleaning and when not in
use.
m CAUTION! RISK OF INJURY!
Only use grinding discs and accessories
u
recommended by the manufacturer. Using
other attachment tools and other accessories
can represent a risk of injury for you.
Only use accessory parts which bear
u
information about the manufacturer, type
of connection, dimension and permitted
number of revolutions.
Only use accessory parts where the printed
u
rotational speed is at least as high as what
has been specified on the name plate of the
product.
Do not use any broken, cracked, or
u
otherwise damaged grinding discs.
Never operate the product without protective
u
equipment.
18 GB
m CAUTION! RISK OF INJURY!
Support the plates or workpieces in order to
u
reduce the risk of kickback from a jammed
cutting disc. Large workpieces may bend
under their own weight. The workpiece must
be supported on both sides of the disc, not
[ 9 ]
only near the cutting disc, but also at the
edge.
Keep your hands away from the disc when
u
the product is in operation. Risk of injury.
˜ Switching the product on/off
m CAUTION! RISK OF INJURY!
The cutting/grinding disc still runs even after
u
the product has been switched off.
NOTE
After switching on the product, wait until the
u
product has reached its max. speed. Only
then should you start with the work.
Switching on: Push the pressure point on the
o
on/off switch
off switch
5 ] [
on and starts.
Switching off: Release the the on/off
o
switch . The product switches off.
[ 5 ]
Trial run
Always carry out a trial run before carrying out
your first grinding procedure and after every disc
replacement. Switch the product off immediately
if the grinding disc is not rotating smoothly, if
considerable vibration occurs or if you hear
abnormal noises.
˜ Checking the battery charge
level
NOTE
The battery indicator
u
charge level of the battery
downwards and slide the on/
[ ]
forwards. The product switches
indicates the
6 ] [
.
9 ] [