x-sense XS01-WX Bedienungsanleitung Seite 9

Note
• Battery life is calculated on current ratings in the weekly test mode and
standby mode. If the operation mode changes to an alarming condition,
the battery life wil be decreasedaccording y.
• This smoke alarm functions between 40 and 1000F (4.4 and 37,80C).
Pro onged exposure to lower or higher temperatures can reduce battery
life and affect device performance. We do not recommend operating the
device outside of this temperature range.
Maintenance
General Maintenance
Follow the steps listed below for optimum ong-term performance:
• Test the device once a week by pressing the Test/SiIence button,
ensuring the device functions properly. Note that this only tests the
electronics in your alarm rather than smoke.
• Cleanthe alarm every three months. Remove the device from the
ceiling or wall and clean the cover and vents with a soft, damp c 0th.
• Be sure to properly relnstall the device after cleaning.
• Do not clean the device with detergents or solvents,or sprayair
fresheners or hair spray nearthe device, asthese may ead to a
malfunction.
• Do not paint the device, asit will sealthe vents and reduce the
sensitlvity of the smoke sensors.
Do not tamper with this device, asthis may ead to electrical shock
or malfunction.
Do not disassemble the device to clean the interior. Doing sowil
void your warranty.
Weekly Test
Test the alarm once a week, when you turn on the device for the first
time, and every time you rep ace the battery or reconfigure the device.
To test the alarm, pressthe Test/SiIence button, and the device shou d
beep three times. [you hold down the Test/SiIence button for onger
than three seconds, the smoke alarm will re-enter the pairing process.
Note that this wil only test the electronics. If the device fails to deliver
an audible test signal, please refer to the Troubleshooting section.
Battery Replacement
1. Removethe smoke alarm from the mounting bracket by twisting
counterclockwise.
2. Take out the old battery and install a new one, making sure to match
the battery's polarities.
3. Test the alarm by pressing the Test/SiIencebutton on the device.
4. Attach the alarm onto the mounting bracket by twisting c ockwise
until it is firm y secured.