x-sense XS01-WX Bedienungsanleitung Seite 4

5. Connect to a GHzWi-Fi network and make sure you enter the
correct password.Then, the smoke alarm will enter the pairing process.
Make sure the Test/SiIence button (the LEDindicator) is still flashing
blue; or else you need to press it to make it flash blue again.
6. When finished, you will seethe smoke alarm on the app's device list.
Note:
f your router supports a dual band network with both 2.4 GHzand 5
GHz,please create separate SSIDsfor the 2.4 GHzand 5 GHzchannels.
This device is only compatib e with a 2.4 GHzWi-Fi network
To promote successfulWi-Fi connection, make sure you place the
alarm within the router range, and that you enter the correct
password,
Set Up a Smoke Alarm
Push Notifications
n alarm, mute, test, low battery, and other states,you will receive push
notifications on the app.
Record History
To accessdata or check device status, tap the History button on the
bottom.
Offline Notifications
Offline notifications are used to notify you if the alarm disconnects from
the Wi FLNote that this notification may not be sent instantly, asthe
alarm reports to cloud service center at set intervals.