VOLTCRAFT SEM5000 DUAL Energy-Logger Bedienungsanleitung Seite 89

3. Restarting the measurement with the same period
Proceed as follows to start another measurement with the
previously set period:
Briefly press the
and the current period setting for the measurement.
Briefly press the
play.
Briefly press the
play.
Briefly press the
and the display does not flash.
Briefly press the
4. Early aborting the measurement
Briefly press the
current time setting.
Press and hold the
normal display is shown.
When the flashing PERIOD disappears, the measure-
ment has been aborted.
button; the display shows PERIOD
button: the day flashes on the dis-
button: the hours flash on the dis-
button: the setup mode is exited
button to start the measurement.
button for the display to show the
button for 3 seconds until the
89