Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the SD card. Make sure that the SD card (not included in the
scope of delivery) is inserted before you use the energy logger
to record the measurement data. Firmware upgrade function only
supports FAT32.
9.1 Connecting devices
You can connect a load (example: space heater) or connect a
suitable energy source to backfeed electricity (example: solar
panel).
Disconnect any devices that may be connected to the energy
logger.
Plug the energy logger into an earthed household mains
socket (230 V/AC, 50 Hz). On start-up, wait until the normal
display appears.
If the device you want to connect to the energy logger has a
mains switch, switch it off.
Plug the mains plug of the device into the earthed mains
socket on the front of the energy logger.
Switch the connected device on and wait a few seconds until
the energy logger shows the first measured data.
Before you can use all functions of the energy logger, you
must first implement a few settings (e.g. time, electricity
tariff).
Important:
The data cannot be properly stored on the SD card until the
date and time have been configured and set.
67
Werbung
