VOLTCRAFT SEM5000 DUAL Energy-Logger Bedienungsanleitung Seite 68

9.2 Entering, using and exiting the setup mode
Press and hold the
setup mode, and briefly press the
will be applied after you close the menu.
Please note:
You can only access the setup mode when the energy log-
ger is in CURRENT mode.
When the display is not flashing, you can also leave the
setup mode by briefly pressing the
will be saved.
When the display is not flashing in the setup mode, use the
button to toggle between the different settings.
You can use the following settings:
– Night mode
– Time and 12/24-hour mode
– Electricity tariff 1 and 2 (cost and start time)
– Standby and low standby limits
– CO
2
– Overload alarm
– Delete mode
Briefly press the
played function.
Briefly Press the
Briefly pressing the
item or ends the input, depending on the setting.
68
emission value for electricity tariff
button to modify the setting of the dis-
button to adjust the flashing value.
button for 3 seconds to enter the
button to exit. Settings
button takes you to the next input
button. Your settings