VOLTCRAFT SEM5000 DUAL Energy-Logger Bedienungsanleitung Seite 75

The energy logger displays the respective CO
connected consumer depending on the power consumption.
Proceed to the next step if you have already set the standby
limit before setting the CO
Or access the setup mode (see chapter 9.2). Pressing the
button four times takes you to the standby limit setup
menu (see next step).
Briefly press the
position for the CO
start to flash).
Use the button
the last input position has been confirmed, the display stops
flashing.
When the display is not flashing, briefly press the
to skip to the next setting or briefly press the
exit the setup menu.
value.
2
button several times to select the input
value (the selected input position will
2
or to modify the flashing value. Once
emissions of the
2
button
button to
75