Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General system information
5 General system information
This device is part of the Homematic IP
smart home system and works with
the Homematic IP radio protocol. All
devices of the system can be confi-
gured comfortably and individually
with the Homematic IP smartphone
app. Alternatively, you can opera-
te the Homematic IP devices via the
Homematic Central Control Unit CCU3
or in connection with various partner
solutions. The available functions pro-
vided by the system in combination
with other components are described
in the Homematic IP User Guide. All
current technical documents and up-
dates are provided at
www.homematic-ip.com.
6 Start-up
6.1
Pairing
Please read this entire section
before starting the pairing proce-
dure.
First set up your Homematic IP
Access Point via the
Homematic IP app to enable ope-
ration of other Homematic IP
devices within your system. For
further information, please refer
to the operating manual of the
Access Point.
For more information on teaching
and setting up the wall thermostat
using a CCU3, please refer to the
WebUI manual on our homepage
at www.homematic-ip.com.
To integrate the temperature and hu-
midity sensor into your system and
enable it to communicate with other
Homematic IP devices, you must pair
the device to your Homematic IP
Access Point first.
To pair the temperature and humiditiy
sensor, please proceed as follows:
• Open the Homematic IP app on
your smartphone.
• Select the menu item "Pair device".
• To remove the sensor (B) from the
frame, take hold of the sides of the
sensor and pull it out.
Figure 3
• Turn over the sensor.
• Remove the insulation strip from
the battery compartment. Pai-
ring mode remains activated for
3 minutes.
18
Werbung
