Samson RINGO 3599 Einbau- Und Bedienungsanleitung Seite 68

Axial-durchgangsventil

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

In accordance with the requirements of the Pressure Equipment

This is to certify that the Quality Management System of

RINGO VALVULAS, S.L. (SAMSON – RINGO)

has been assessed against the requirements of Annex III, Module H of the Pressure

Equipment Directive 2014/68/EU and conforms to the requirements for the products shown

Design and manufacturing of pressure accessories. Gate, globe, check, ball, butterfly, plug,

diaphragm, control, axial and special valves for industrial applications. (Pressure, materials

Approval is subject to the continued maintenance of the quality system in accordance with

the requirements of the above Directive for the products listed on the attached schedule.

Authorisation is hereby given to use the LRQA Inspection Iberia, S.A Notified Body

Identification Number in accordance with the requirements of the specified Directive in

Certificate No:

Original Approval:

Current Certificate:

Certificate Expiry:

LRQA Inspection Iberia, S.A Notified Body 0094

LRQA Inspection Iberia, S.A. is a company registered in the R. M. de Madrid, in Volume 5218 general, 4358, of Section Sec. 3.ª of the Companies Book, folio 133 sheet nº 41397, inscription. 1.ª

LRQA Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'LRQA'. LRQA assumes no responsibility and

shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the

relevant LRQA entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract.

14-2

EU CERTIFICATE OF CONFORMITY

Directive 2014/68/EU

Pol. Industrial Empresarium

C/ Romero nº 6 y 8

50720 – La Cartuja (ZARAGOZA) -Spain

below:

and dimensions detailed in certificate schedule)

relation to the products as identified above.

0094/PED/MAD/0132 ENG

20 December 2020

22 May 2023