Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The noise and vibration values have been determined
through a standardised measurement process.
Noise data
Sound pressure L
pA
Sound pressure L
wA
Measurement uncertainty K
Vibration parameters
Vibration a
h
Measurement uncertainty K
The total vibration emission values specified and the
device emissions values specified have been measured
in accordance with a standardised test procedure and
can be used for comparison of one electric tool with an-
other.
The total noise emission values specified and the total
vibration emission values specified can also be used for
an initial estimation of the load.
WARNING
The noise emission values and vibration
emission value can vary from the specified
values during the actual use of the power
tool, depending on the type and the manner
in which the electric tool is used, and in
particular the type of workpiece being pro-
cessed.
Try to keep the stress as low as possible. For exam-
ple: Limit working time. In doing so, all parts of the
operating cycle must be taken into account (such as
times in which the power tool is switched off or times
in which it is switched on, but is not running under a
load).
7
Unpacking
WARNING
The product and the packaging material are not
children's toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. Immediately report any damage to the
transport company that delivered the Product. Later
claims will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
76.3 dB
• With accessories as well as wearing parts and re-
88.7 dB
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
2.03 dB
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
2
2.03 m/s
2
1.5 m/s
8
Assembly
DANGER
Danger of injury!
If an incompletely assembled product is used, serious
injuries can be caused.
–
Do not use the product until it has been fully fitted.
–
Before each use, carry out a visual inspection to
check that the product is complete and does not
contain any damaged or worn components. Safe-
ty and protective devices must be intact.
WARNING
Do not use your product until it is completely assem-
bled and installed according to the instructions.
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
8.1
Fitting the protective cover (12)
(Fig. 2)
1. Slide the protective cover (12) into the recesses on
the motor head (15).
The protective cover (12) clicks into place audibly.
2. Screw the protective cover (12) tight with the Phil-
lips screw (12a).
Use the Phillips screwdriver included in the scope of
delivery.
8.2
Fitting the spacer bar (13) (Fig. 1)
Note:
The spacer bar keeps plants and stems that cannot be
cut away from the cutting device.
1. Fit the spacer bar (13) to the front of the motor head
(15).
www.scheppach.com
GB | 23
Werbung
