Sage the Oracle Jet SES985 Handbuch Seite 16

PROBLEM
The machine is 'On'
but won't operate
Espresso only
drips from the
portafilter spouts,
restricted flow
Espresso flows
out too quickly
No crema
Not enough
milk texture
I cannot connect my
machine to the Wi-Fi
No Wi-Fi router
available
No mobile phone
hot-spot available
16
POSSIBLE CAUSE
• Coffee is ground too finely.
• The coffee is ground too
coarsely.
• Coffee beans are stale.
• Coffee beans are stale.
• Steam wand is blocked.
• Wrong password entered
for the SSID.
• Check the router proximity,
signal strength might be
weak.
• No device available to
provide internet access.
• No device available to
provide internet access.
WHAT TO DO
• Switch off the machine, unplug from the
power outlet, then plug the machine to the
power outlet and turn the machine back on.
• If problem persists, call Breville
Consumer Support.
• Adjust the grind size to a higher number to
make the grind size slightly coarser.
• There may be a blockage due to scale
build up. Run the descale process.
• Adjust the grind size to a lower number to
make the grind size slightly finer.
• Use freshly roasted coffee beans with a
'Roasted On' date and consume between
5–20 days after that date.
• Use freshly roasted coffee beans with a
'Roasted On' date and consume between
5–20 days after that date.
• Refer to 'Cleaning the Steam Wand'.
• There may be a blockage due to scale
build up. Run the descale process.
• Different brands and types of milk and milk
alternatives will texture differently. You may
need to adjust the froth level accordingly.
• Unplug and plug the machine into the
powerpoint.
• Retry entering Wi-Fi credentials again.
• Install the router closer to the appliance for
stronger signal strength.
• Try using a mobile phone hot-spot.
• For optimal performance, it is highly
recommended to purchase a Wi-Fi router.
• To skip the Wi-Fi selection, follow these
steps:
3) Enter the "Select your network" mode.
4) Select "Other" if there is no internet.
5) Click the arrow button in the top right
corner to skip the "Network" selection.
6) Click the arrow button in the top right
corner to skip the "Password" entry.
7) A "Connecting" error is likely to occur.
• Select "Try again" and repeat above steps.
• After the second failed attempt, choose
"Update later" to skip the Wi-Fi setup.