Progress PBD46103X Benutzerinformation Seite 9

Temperature
The current temperature is indicated.
Temperature
You can change the temperature.
Core temperature sensor
The core temperature sensor is in the
core temperature sensor socket.
Light
You deactivated the light.
Minute minder
The minute minder function operates.
Water drawer indicator
Shows the water level
5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 Initial preheating and cleaning
Preheat the empty appliance before the first
use and contact with food. The appliance can
emit unpleasant smell and smoke. Ventilate
the room during preheating.
1. Remove all accessories and removable
shelf supports from the appliance.
2. Set the function
temperature. Let the appliance operate
for 1 h.
3. Set the function
temperature. Let the appliance operate
for 15 min.
4. Set the function
temperature. Let the appliance operate
for 15 min.
5. Turn off the appliance and wait until it is
cold.
6. Clean the appliance and the accessories
only with a microfibre cloth, warm water
and a mild detergent.
7. Put the accessories and removable shelf
supports back to their initial position.
. Set the maximum
. Set the maximum
. Set the maximum
An automatic programme with a weight
input operates.
/
A clock function operates.
/
4.3 Heat up indicator
If you turn on the heating function,
appears. The bars show that the temperature
in the oven increases or decreases.
When the oven is at the set temperature, the
bars go off the display.
5.2 Setting the water hardness level
When you connect the appliance to the mains
you have to set the water hardness level.
Use the test paper supplied with the steam
set.
1. Put the test paper into the tap water for
about 1 sec. Do not put the test paper
under running water.
2. Shake the test paper to remove any
remaining water.
3. After 1 min, check water hardness with
the table below.
4. Set the water hardness level in the menu:
Settings. Refer to "Additional functions"
chapter, Using the settings menu.
The colours of the test paper continue to
change. Check the water hardness within 1
min after testing.
You can change the water hardness level in
the menu: Settings.
The table shows water hardness range (dH)
with the corresponding level of Calcium
deposit and the water classification. Adjust
the water hardness level according to the
table.
When the tap water hardness level is 4, fill
the water drawer with still bottled water.
ENGLISH 9