Progress PBD46103X Benutzerinformation Seite 26

Problem
The descaling procedure is inter‐
rupted before it finishes.
The descaling procedure is inter‐
rupted before it finishes.
There is no water inside the
grill- / roasting pan after the des‐
caling procedure.
There is dirty water on the bottom
of the cavity after the descaling
cycle.
The cleaning function is interrup‐
ted before it finishes.
The cleaning function is interrup‐
ted before it finishes.
There is too much water on the
bottom of the cavity after the end
of the cleaning function.
There is no good performance of
the cleaning procedure.
There is no good performance of
the cleaning procedure.
There is no good performance of
the cleaning procedure.
The appliance is activated and
does not heat up. The fan does
not operate. The display shows
"Demo"
.
13.2 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
26 ENGLISH
Possible cause
There was a power cut.
The function was stopped by the
user.
You did not fill the water drawer
to the maximum level.
The grill- / roasting pan is on a
wrong shelf position.
There was a power cut.
The function was stopped by the
user.
You sprayed too much detergent
in the appliance before the acti‐
vation of the cleaning cycle.
The initial oven cavity tempera‐
ture of the steam cleaning func‐
tion was too high.
You did not remove the side grids
before the start of the cleaning
procedure. They can transfer
heat to the walls and decrease
the performance.
You did not remove the accesso‐
ries from the appliance before the
start of the cleaning procedure.
They can compromise the steam
cycle and decrease the perform‐
ance.
The demo mode is activated.
The necessary data for the service centre is
on the rating plate. The rating plate is located
on the front frame of the appliance. It is
Remedy
Repeat the procedure.
Repeat the procedure.
Check if the a descaling agent /
water is present in the water
drawer body.
Repeat the procedure.
Remove the residual water and
the descaling agent from the bot‐
tom of the oven. Put the grill- /
roasting pan on the first shelf po‐
sition.
Repeat the procedure.
Repeat the procedure.
Cover all parts of the cavity with a
thin layer of the detergent. Spray
the detergent evenly.
Repeat the cycle. Run the cycle
when the appliance is cold.
Remove the side grids from the
appliance and repeat the func‐
tion.
Remove the accessories from the
appliance and repeat the func‐
tion.
Refer to "Using the settings
menu" in "Additional functions"
chapter.