Progress PBD46103X Benutzerinformation Seite 23

12.7 How to use: Descaling - S3
When the steam generator operates, there is
an accumulation and deposition of limestone
inside because of calcium contents in the
water. This can have a negative effect on the
steam quality, on the performance of the
steam generator and on the food quality. To
prevent this, clean the steam generation
circuit from residual stone.
1. Make sure the appliance is cold.
2. Remove all accessories and removable
shelf supports.
3. Make sure that the water drawer is
empty. If necessary, turn on the function:
Tank Emptying - S1.
4. Turn on the appliance.
5. Place the deep pan on the first shelf
position.
6. Put 250 ml of the descaling agent in the
water drawer.
7. Fill the remaining part of the water drawer
with water to the maximum level until the
signal sounds or the display shows the
message.
8. - press repeatedly until the display
shows S3.
Duration: 1 h 40 min
9. When the function ends, remove the deep
pan.
When this function works, the lamp is off.
10. When the appliance is cold, dry the cavity
with a soft cloth.
11. Leave the oven door open and wait until
the oven interior is dry.
12. Turn on the function: Rinsing. Refer to
Care and Cleaning chapter, "How to use:
Rinsing - S4".
If some limestone residue remains in the
appliance after descaling, the display prompts
to repeat the procedure.
12.8 Descaling reminder
There are two reminders which prompt you to
descale the appliance. You cannot disable
the descaling reminder.
• Soft reminder - recommends you to
descale the appliance.
• Hard reminder - obligates you to descale
the appliance. If you do not descale the
appliance when the hard reminder is on,
the steam functions are disabled.
When the reminders are active S3 flashes on
the display. These reminders activate each
time you turn off the appliance.
12.9 How to use: Rinsing - S4
1. Make sure the appliance is cold.
2. Remove all accessories and removable
shelf supports.
3. Turn on the appliance.
4. Place the deep pan on the first shelf
position.
5. Fill the water drawer with water to the
maximum level until the signal sounds or
the display shows the message.
6. - press repeatedly until the display
shows S4.
Duration: 30 min
7. When this function works, the lamp is off.
When the function ends, remove the deep
pan.
8. Turn off the appliance and wait until it is
cold. Leave the oven door open and wait
until the oven interior is dry.
12.10 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Fully open the door.
2. Lift and press the clamping levers
the two door hinges.
A
on
A
ENGLISH 23