Parameter Setting - Quick Tools Quick 709D+ Bedienungsanleitung

Enter the initial password
1. The window shows "- - -" and the leftmost digit flashes, at this time the
digit can be adjusted (i.e. enter the initial password).
2. Enter the initial password: adjust the middle knob to change the
hundreds' digit, press the "▲" button to move the digit, and then the
tens' digit will start flashing to be set, and the tens' and units' digit will
be set in the same way as the hundreds' digit. When the digit is set,
press and hold the "▲" and "▼" button at the same time to confirm.
3. If the first password is wrong: then directly enter the second
password, and the input way is the same. (There are two chances of
password input. If the first password is wrong, you can directly enter the
second password.)
4. If the password entered twice is wrong: The menu will show
"ERR", and then directly enter the main interface.
5. If the first or second password is correct: then go directly to
parameter setting and the window shows "-1-".

2.7.2. Parameter setting

1. If password is entered correctly, the parameter menu can be entered,
as shown in the following figure
2. Click "▲" or "▼" button. After selecting -1- parameter menu, return to
the main interface directly; after selecting -2- parameter menu, press
"▲" and "▼" button at the same time to enter the new password
setting.
7
USER MANUAL