Settings; Password Setting - Quick Tools Quick 709D+ Bedienungsanleitung

 Plug a hot air nozzle onto the hot air iron and place it in the storage
stand.
 Insert the power plug into an earthed socket and switch the unit on at
the power switch.
 When the hot air piston is taken out of the storage stand, the unit
switches to working mode.
 If no password has been assigned or the password has been entered
correctly beforehand, the temperature and the air flow can be changed.
 Always place the hot air pen in the storage stand during work breaks.
The cooling function is automatically started until less than 100°C is
reached. The station then switches to standby.
 If the station is not used for a longer period of time, it should be
switched off at the power switch.
2.7.

Settings

2.7.1. Password setting

The initial password is "000", and in this state, you can set the temperature. If
you need to limit the temperature adjustment, you must change the password.
Enter password setting mode
1. Turn off the system, press the "▲" and "▼" buttons at the same
time, and then turn on the system.
2. Press and hold the "▲" and "▼" buttons, C will be displayed after a
beep, and the "---" display will pop up on the interface.
3. After entering the correct password, go to parameter setting.
6
USER MANUAL