Introduction; Intended Use; Features; Technical Data - Parkside PDBS 2200 A1 Bedienungs- Und Sicherheitshinweise

Introduction

The following pictograms are used in these operating instructions / on the device:
Refer to operating manual!
Note
Follow warnings and safety notices!
Never use hydrogen, oxygen, carbon
dioxide or other bottled gasses as an
power source
Pneumatic drill PDBS 2200 A1
Introduction
Congratulations! You have chosen a
high-quality device from our company.
Familiarise yourself with the product
before using it for the first time. In addition, please
carefully refer to the operating instructions and the
safety advice below. Initial operation of this tool
must be performed by trained personnel.
KEEP OUT OF THE REACH OF CHILDREN!

Intended use

This air-powered drill is suitable for drilling into
plastic, wood, metal and similar materials. Only
use the product as described and for the indicated
purpose. Keep these instructions in a safe place.
When passing this product on to others, please
also include all the documents. Any use other than
the intended is prohibited and potentially dange-
rous. Damages resulting from noncompliance or mi-
suse are not covered by the warranty and are not
included in the manufacturer's liability. This device
has been designed for household use and may not
be used for commercial or industrial purposes.
6 GB/IE
110140_par_Druckluft Bohrmaschine PDBM_content_GB_IE_FI_SE_DK.indd 6
Oil daily
Wear ear protection, dust mask, safety
glasses and protective gloves.
Compressed air hose
Dispose of packaging and device in an
environmentally friendly way!

Features

Verify contents are complete and the de-
vice is in perfect condition immediately
after unpacking. Do not use if the tool is
defective.
Keyed chuck
1
Drill head
2
On/ Off switch
3
Forward/reverse switch
4
Compressed air connection
5
Coupling
6
Air outlet
7
Accessories
Male coupling ¼"
8
Wrench
9
Bits
10
Bit extension inside bit box
11
Metal drill
12

Technical Data

Operating pressure: max. 6.8 bar
Speed max.: 2200
Collar: 1–10 mm
suitable for: Wood and metal drill bits
as well as standard bits
Air supply: via service unit with filter
pressure reducer and oil
atomiser
rpm
30.06.15 09:51