Werbung
EN
TROUBLESHOOTING
If the device does not work properly, check
whether you are able to rectify the problem
yourself. If the problem cannot be solved
with the steps below, contact the customer
service department.
Do not attempt to repair an elec-
trical device yourself!
The device does not start.
The battery (2) is empty.
► Charge up the battery.
The device is connected to the mains power.
► Disconnect the connecting cable (E).
Low suction force.
The battery (2) is weak.
► Charge up the battery.
The dust container (11) is too full.
► Empty the dust container.
The filters (13, 14) are dirty.
► Clean the filters.
The suction opening (12), a nozzle (A, B, F)
or the extension tube (D) is blocked.
► Switch off the device and remove the
blockage.
The dirt particles are too large or too heavy.
► Switch off the device and remove dirt
particles by hand.
TECHNICAL DATA
Article number:
ID of operating instructions:
Device
Model number:
Voltage supply:
Power:
Battery charge time:
Battery operating time:
18
Dust escapes from the device during
cleaning.
The dust container (11) is not closed cor
rectly.
► Close the dust container flap (9) until it
is heard to engage.
The filters (13, 14) are not fitted correctly.
► Correct the fit of the filters.
The filters are dirty.
► Clean the filters.
The filters are worn or damaged.
► Replace the filters.
The charge control lamps (3) do not
flash when the device is connected to
the mains power.
The power supply is not inserted in the plug
socket correctly or the barrel connector is
not inserted in the charging socket (5) of the
device correctly.
► Correct the fit.
The plug socket is defective.
► Try another plug socket.
You notice an unusual odour during
cleaning.
The device is being used for the first time.
► A new odour is normal when the device
is used for the first time; it disappears
after a while.
13475
Z 13475 M DS V1 1123 uh
B846A
22.2 V DC (Liion battery pack; 2 200 mAh)
150 W
4 – 5 hours
approx. 40 – 45 minutes (with fully charged battery)
Werbung
Fehlerbehebung
