Accessories; Use - Cleanmaxx Plus B-846A Bedienungsanleitung

EN

ACCESSORIES

The floor nozzle (F) is suitable for both car­
pets and hard floors.
The floor nozzle can be used both with the
extension tube (D) and directly on the motor
unit (C).
The combi nozzle (A) is a combination of a
small crevice nozzle and brush nozzle. Press
the release button on the brush attachment
and slide it upwards at the same time to
convert the crevice nozzle into a brush noz­
zle (Picture F). The brush attachment must
be heard to engage in place:
○ The small crevice nozzle is suitable for
upholstery, cleaning the inside of cars
and for all nooks and crannies.
○ The brush nozzle is used for vacuuming
upholstery and textiles and for remov­
ing dust from delicate objects such as
picture frames, lamp shades, keyboards,
books etc.
The crevice nozzle (B)) is ideal for places
which are hard to get to, such as corners,
crevices or recesses, and all nooks and
crannies that cannot be reached with other
nozzles.
The extension tube is intended to be used
with the floor nozzle for cleaning floors
(Picture D). In addition, it makes it easier to
reach ceilings and corners.
The wall mounting bracket (G) is suitable for
storing the device in a space­saving manner.
16

USE

Please Note!
■ Ensure that there are no larger, sharp
objects on the surface which is to be
cleaned.
■ Note the MAX marking of the dust con­
tainer. If the marking is reached during
use, empty the dust container. Empty
and clean the dust container after every
use. The filters must also be cleaned
regularly to prevent the motor from
being overloaded (see the "Cleaning and
Storage" chapter).
■ Switch off the device after you finish
cleaning each surface to increase the
operating time on each battery charge.
L
The device cannot be operated
when it is connected to the mains
power. Disconnect the connecting
cable (E) prior to use.
1. Select a nozzle (see the "Accessories"
chapter) and plug it into the suction
opening (12). For a longer reach, plug
the extension tube (D) in between.
To pull the floor nozzle (F) or extension
tube out again, press the release button
on the extension tube or floor nozzle.
The other two nozzles can simply be
pulled out.
2. Switch on the device and guide the
nozzle over the area to be cleaned. To
switch on at suction level 1, press the
On / Off switch (6) once. The suction
power is increased by pressing the MAX
button (4).
3. To switch off the device, briefly press the
On / Off switch again.
L
To ensure optimum performance of
the device, empty and if necessary
clean the dust container after every
use (see next chapter).