Shark S6003EU Bedienungsanleitung Seite 25

INTELLIGENT STEAM CONTROL
The Shark® Klik n' Flip
SETTING
Automatic Steam Mop
has 3 unique Intelligent
Steam Control settings
so you can use the right
LOW
amount of steam for the
cleaning task at hand. See
below for tips on when to
use each setting.
* Sanitisation studies were
conducted under controlled
MED
test conditions. Household
conditions and results may
vary. With Klik n' Flip Mop in
HI mode only when used with
Steam Mop. Not in Steam
Blaster mode.
Steam
Blaster
TO SANITISE* WITH THE STEAM MOP USING THE KLIK
N' FLIP MOP HEAD AND THE DIRT GRIP PAD:
1 Attach a clean Dirt Grip pad to the Klik N' Flip
Mop Head.
2 Plug in the unit and press the Steam Control Button to
select the HI Setting.
3 Wait 30 seconds for the unit to begin producing steam.
4 Start mopping on an appropriate sealed hard-floor
surface with a forward and backward motion. After
three minutes, your unit is ready to be used to sanitise.
5 Using a forward and backward motion, move the unit
over the area you seek to sanitise. Repeat at least
5 times.
47
®
IDEAL FOR RECOMMENDED USAGE
THESE
SEALED
SURFACES
Laminate Cleaning delicate surfaces
Hardwood Light cleaning and dusting
Marble Loosening and lifting light dirt
Cleaning sealed surfaces and
large areas
Hardwood
Basic, everyday cleaning
Marble
Removing spots and smaller
Tile
messes
Stone
Cleaning moderate and heavy
traffic areas
Deep cleaning and cleaning
HI
hard-to-clean surfaces
Hardwood
Tough cleaning and removing
Marble
stuck-on messes and stains
Tile
Deep cleaning heavy traffic areas
Stone
Cutting through heavy dirt and
grime
For an extra burst of steam, you can use the
Steam Blaster feature in LOW, MED and HI.
Follow the instructions found on the "Using
™
your Automatic Steam Mop" page.
CARING FOR YOUR SHARK® KLIK N' FLIP
AUTOMATIC STEAM MOP
fig. 12
fig. 13
AFTER USE AND STORAGE
1 Press the Steam Control Button until
the three lights below start to blink,
indicating that you are in Standby
mode. Unplug the cord from the outlet
and place the Steam Mop into the
upright position. Let it cool.
2 To remove the Dirt Grip Pad, lift
the Steam Mop straight up by the
handle until the Klik n' Flip Mop Head
is hanging straight down. Press the
Release button on the back of the
Steam Mop body, and both sides of the
Klik n' Flip Mop Head will drop open,
releasing the pad. Once the pad has
been released, close the Klik n' Flip
Mop Head.
3 If the Klik n' Flip Mop Head is not
attached to the mop, the pad can
still be removed. Press the two red
secondary pad release buttons located
on the sides of the Klik n' Flip Mop
Head post to release the pad. (fig. 12)
4 Empty the water tank before storing.
To empty the tank, hold the Steam
Mop beside a sink. Open the water
tank lid, then lean the unit over the
sink. Let the water drain out, then close
the lid.
5 To store the Steam Mop, wait until
after it has cooled and the steam has
been released. Then remove the Klik
n' Flip Mop Head and hang the Steam
Mop by its handle on a large hook (not
included). (fig. 13).
s ha rkc l ea n.eu
48