Shark S6003EU Bedienungsanleitung Seite 24

USING YOUR SHARK® KLIK N' FLIP
AUTOMATIC STEAM MOP
IMPORTANT: Make sure
you do not use the Steam
Mop without attaching a
Dirt Grip Pad and adding
water to the water tank
first. When you are using
the Steam Mop for the
first time, it might take
longer than the normal 30
seconds to start steaming.
IMPORTANT: Do not use
on unsealed wood or
unglazed ceramic floors.
On surfaces that have
been treated with wax
and on some no-wax
floors, the sheen may
be removed by the heat
and steam action. Test
an isolated area of the
surface to be cleaned
before proceeding.
Check the use and care
instructions from the
1
Twist the Quick-Release Cord Holder to unwrap
floor manufacturer.
the power cord completely. (fig. 9) Plug into an
electrical outlet.
TIP: To prolong the life
2 When it's first plugged in, the unit will be in
of your Steam Mop,
Standby mode. The 3 lights below the
we recommend using
Steam Control Button will blink to indicate
distilled water.
Standby mode.
TIP: Sweep or vacuum
3 To select the steam mode, press the Steam
your floors prior to
Control Button once for LOW (1 blue light) twice
cleaning with your
for MED (2 blue lights) or three times for HI
Steam Mop.
(3 blue lights).
CAUTION: While in Steam
4 Clean your floors with a forward and
Blaster mode, do not leave
backward motion.
stationary for more than
5 When you need an extra burst of steam to clean
one minute.
a stuck-on stain, you can use the Steam Blaster™
CAUTION: Do not scrub
feature. Flip the head over so that it is behind the
any one area for an
mop body, then tilt the mop handle down. This
extended period of time.
will cause the Steam Blaster (fig. 10) to emit
a concentrated blast of steam onto the stain.
45
6 To stop the Steam Blaster spray,
simply raise the handle. You can
then flip the mop head back into
its original position and continue
cleaning.
7 When finished mopping, press the
Steam Control Button. The three
blue lights will blink, indicating that
the unit is in Standby mode. Once in
Standby mode, unplug the unit.
8 To remove the Dirt Grip Pad, simply
lift the Steam Mop straight up by the
handle until the Klik n' Flip Mop Head
is hanging straight down. Press the
Release button on the back of the
Steam Mop body (fig 11a), and both
sides of the head will drop open,
releasing the pad. (fig 11b)
9 Once the Dirt Grip pad has been
released, close the Klik n' Flip Mop
Head. To close, gently press one side
of the Klik n' Flip Mop Head to the
floor until that side clicks into place.
Repeat on the other side.
10 When the water tank is empty, the
Steam Mop will stop producing
steam. You can refill the water tank at
any time as long as the Steam Mop
is unplugged. Follow the water tank
filling instructions on page 6.
NOTE: Please wait 2 to 3 minutes for
the Steam Mop to cool off before
switching the mop head. Never leave
the Steam Mop with a damp/wet Dirt
Grip pad on any floor for an extended
period of time.
s ha rkc l ea n.eu
46