Herunterladen Diese Seite drucken

Shark S6003EU Bedienungsanleitung Seite 27

Vorschau ausblenden Andere Handbücher für S6003EU:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 11
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE REASONS & SOLUTIONS
The Steam Mop should be securely plugged into an electrical outlet.
Check your fuse or circuit breaker or try a different outlet.
Make sure the water tank is full, the unit is plugged in, and the light
around the Steam Control Button is solid.
If the lights below the Steam Control Button are not illuminated, try a
The Steam Mop
different electrical outlet.
isn't producing
If the lights below the Steam Control Button are blinking, press the
any steam�
Steam Control Button to select a Steam setting.
If the lights below the Steam Control Button are solid, wait 30 seconds
for the unit to warm up.
If after following the above steps the Steam Mop still does not produce
any steam, contact Customer Service at 0800 862 0453 or www.
sharkclean.co.uk.
The Steam Mop
This is normal—for more consistent steam select the HI setting.
is producing
Also make sure the water tank is full.
intermittent steam�
Make sure the Steam Mop is plugged in and the lights below the Steam
I can't select a
Control Button are solid.
Steam Setting�
If your Steam Mop is producing steam but the lights below the Steam
Control Button are not lit, call customer service at 0800 862 0453.
The Dirt Grip Pad might be dirty. If it is, flip it over to the clean side
or change it entirely. If you washed the Dirt Grip pad with powdered
detergent, then it could be damaged and require replacement.
This could also be an indication of soap or grease residue that has
accumulated on the floor. As the Steam Mop uses only a small amount
of water, it may not be enough to rinse off the accumulation of residue
that the steam is bringing to the surface. We suggest rinsing the floor
I am getting
with nothing but water, letting it dry, and then steam mopping again
with a clean Dirt Grip pad. One or more rinses will generally remove the
streaky/cloudy
residue.
floors�
A more stubborn case may require you to rinse the floor with a mix of
one part vinegar and two parts water* (but DO NOT put any cleaning
solutions or chemicals into the Steam Mop's water tank. Adding
chemicals or cleaning solutions (including vinegar) will void your
warranty and may damage the Steam Mop.)
*Please consult your flooring manufacturer's care and maintenance
instructions before applying any cleaning products or solutions.
The Steam Mop might be hard to push/pull if the Dirt Grip pad isn't wet
It's really hard for
enough. It should get easier to push/pull the Steam Mop after it's been
me to push/pull
running for a few minutes.
the Steam Mop�
An overly dirty pad could also result in a harder push/pull experience.
We recommend flipping the pad over or using a clean pad.
51
51
FREQUENTLY ASKED QUESTIONS
QUESTION
ANSWER
Can I use the Steam
No, the Steam Mop is not designed for carpet cleaning.
Mop on carpets?
The Steam Mop is designed for use on all sealed hard-floor
surfaces. We recommend that you first test an isolated
area of the floor surface to be cleaned as well as review
the use and care instructions from your floor manufacturer.
What surfaces can
WARNING: Do not use on leather, wax-polished furniture,
I use the Steam
synthetic fabrics, velvet, or other delicate, steam-
Mop on?
sensitive materials�
NOTE: On surfaces treated with wax and on some no-wax
floors, the sheen may be removed by the heat or steam
action of the unit. Test an isolated area of flooring first to
see if sheen is affected.
DO NOT add cleaning solutions, scented perfumes, oils, or
Can I put something
any other chemicals to the water used in this appliance,as
other than water in
this will void your warranty and may damage the unit or
the water tank of
make it unsafe for use. We recommend using distilled
the Steam Mop?
water in your Steam Mop.
52
s ha rkc l ea n.eu

Werbung

loading