Storage; Self-Cleaning Function - Cleanmaxx SG5509S8 Gebrauchsanleitung

EN
5. Empty the water reservoir. To do this, fl ip open the water reservoir cover, hold the iron
over a sink or similar outlet and turn it upside down. Allow all of the water to fl ow out
of the reservoir.
6. Then connect the iron to the mains power and move the steam quantity control and
temperature control to the maximum setting for one to two minutes so that the rest
of the water evaporates. Hold it horizontal as you do this. Then repeat steps 1 to 4.
7. If necessary, wipe down the outside of the device with a soft, slightly damp cloth and
then dry it with a soft cloth.

Storage

1. Once the device has completely cooled down and the water reservoir is empty (see
the "Use" chapter, "After Use" section), wind up the mains cable.
2. Store the device in a dry, clean, frost-free location which is out of the reach of children
and animals. When you do this, place the device upright on its base on a fl at, stable
surface.

Self-Cleaning Function

CAUTION!
• Danger of scalding! Hot water and steam will emerge from the bottom of the iron dur-
ing the self-cleaning process. Keep the bottom of the iron away from all body parts
and delicate materials when you press the Self Clean button for self-cleaning (7)!
• Only ever press the Self Clean button to perform self-cleaning and not during ironing!
The device has a self-cleaning function allowing limescale residues to be removed from
the device. Additional descaling of the device is not necessary. Perform the working
steps which are described below regularly (at least every 10 operating hours):
1. Fill the water reservoir up to the MAX marking with water (see the "Use" chapter,
"Filling the Water Reservoir" section). Ideally you should use distilled water for self-
cleaning.
2. Insert the mains plug into a properly installed mains socket that is easily accessible.
3. Heat the device up to the highest temperature setting.
4. Remove the mains plug from the mains socket.
5. Hold the device horizontally over a sink or similar outlet.
6. Press the Self Clean button (7).
7. Allow the water reservoir to run completely empty. Tilt the device back and forth
slightly to allow the water to run out of all nozzles.
8. Repeat the cleaning process several times until no more limescale residues emerge
from the nozzles.
9. If you need to, operate the device again for a short time in order to allow any remain-
ing amounts of water to evaporate.
26