Before Initial Use - Cleanmaxx SG5509S8 Gebrauchsanleitung

EN
2. As soon as you let go of the handle (16), the device automatically goes back into
stand-by (automatic safety switch-off function) and the operating lamp fl ashes.
CAUTION: It takes a little while for the bottom of the iron to cool down. Even
once the device is in stand-by mode, never leave it unattended while it is
still connected to the mains power!
3. If you touch the handle, the device switches on (automatic switch-on function) and
the operating lamp lights up constantly.
• The anti-drip system prevents water from dripping out of the bottom of the iron at
low temperatures by switching off the steam generation function. NOTE: The anti-drip
system may cause a clicking noise during the heating-up or cooling-down process.
This is normal and does not indicate a defect.
• Thanks to the ceramic coating on the bottom of the iron, the device slides effort-
lessly over the fabric during ironing.
• The anti-limescale system of the device removes the lime from the water if you use
tap water instead of distilled water for steam-ironing.
• The self-cleaning function (Self Clean button (7)) allows you to remove limescale
residues from the device, see the "Self-Cleaning Function" chapter.

Before Initial Use

CAUTION!
• Danger of suffocation from plastic fi lms and bags! Keep children and animals away
from the packaging material.
• Water residues in the water reservoir are attributable to the fact that this device has
been tested and do not constitute a defect.
• Unpack the items supplied and check them for completeness (see the "Items Sup-
plied and Device Overview" chapter) and transport damage. If the device, plug or
mains cable does have damage, do not use the device(!), but contact our customer
service department.
• Before using the device, remove all packaging materials and any labels that may be
on the device and are used for protection during transportation or for advertising.
• Before you use the iron on an item of clothing for the fi rst time, iron over a damp scrap
piece of fabric to remove any possible production residues from the bottom of the iron
(see the "Use" chapter).
• It is essential that you read through the "Ironing Recommendations" chapter before
you fi rst use the device!
22