Cleanmaxx SG5509S8 Gebrauchsanleitung Seite 24

EN
• Place the device on an even, stable and heat-resistant surface during and shortly af-
ter use. Always place the device upright on its base to prevent damage to the surface
which could be caused by the hot bottom section of the iron.
NOTE: You might notice a slight odour the fi rst time you use the device. This is harmless
and will cease as you use the device.
Filling the Water Reservoir
CAUTION!
• Always pull out the mains plug before you top up/empty the water reservoir. Always
pull the plug and never the cable.
• Never pour any cleaning agent or other additives into the device. This could destroy
the device and safe working is no longer guaranteed.
• Never exceed the maximum fi ll level (note MAX marking on the water reservoir!). The
useful service life of the device will be extended if you use pure distilled water.
The water reservoir needs to be fi lled for steam-ironing or spraying. If you only want to
dry-iron, there is no need for this.
1. Make sure that the device is not connected to the mains power. Move the steam
quantity control (13) to position 0 and the temperature control (6) to MIN. Turn the
temperature control until MIN is positioned next to the marking (5).
2. Flip open the water reservoir cover (12). Please note that the cover cannot be com-
pletely detached from the device.
3. Place the device with the bottom of the iron (8) on a fl at surface and tilt the tip of the
bottom of the iron up at an angle of around 45°.
4. Fill the reservoir up to the MAX marking (10) with the measuring cup which is also
provided (17). The reservoir holds approx. 300 ml.
5. Close the water reservoir by fl ipping the cover shut again. Make sure that the water
reservoir is completely sealed shut.
Ironing
CAUTION!
• Never aim the steam directly at people, animals or plants. This can cause severe
scalding.
1. Place the iron vertically on an ironing board.
2. Insert the mains plug into a properly installed mains socket that is easily accessible.
The operating lamp (4) will light up.
24
3. Check the label in the garment for the required ironing
temperature and set this using the temperature control (6).
Turn the temperature setting you want to the marking (5).