Spray Function; After Use; Storage - Cleanmaxx Z01211 Gebrauchsanleitung

EN
5. Press the
front of or on the fabric and then release the button again.
6. Wait a few seconds before you press the button again. NOTE: The lower the ironing
temperature, the weaker the production of steam and the longer it takes for more
steam to be produced.

Spray Function

The spray function is suitable, for example, for moistening delicate textiles which cannot
be steam-ironed. This function is independent of the steam function and is possible at
any temperature. NOTE: The water reservoir (6) must have been fi lled (see the "Filling
the Water Reservoir" section).

After Use

1. Once you have fi nished ironing, move the steam quantity control (10) to position 0
and the temperature control (5) to position MIN (off).
2. Place the device vertically onto the base.
3. Remove the mains plug from the plug socket.
4. Allow the bottom of the iron (7) to cool down completely.
5. Empty the water reservoir (6). To do this, open the water reservoir cap (9), hold the
iron over a sink or similar outlet and turn it upside down. Allow all of the water to fl ow
out of the reservoir.
6. Then connect the iron to the mains power and move the steam quantity control (10)
and temperature control (5) to the maximum setting for one to two minutes so that
the rest of the water evaporates. Then repeat steps 3 to 5.
7. If necessary, wipe down the outside of the device or the storage station with a soft,
slightly damp cloth and dry it with a soft cloth.

Storage

• Once the device has completely cooled down and the water reservoir (6) is empty
(see the "Use" chapter, "After Use" section).
• Store the device in a dry, clean, frost-free location which is out of the reach of child-
ren and animals.
button for a steam blast (11), move the bottom of the iron (7) a little in
• Press the
sprayed through the spray nozzle (8) onto the fabric.
24
spray button (12) a few times. Water will be