Scheppach ACS3000 Originalbetriebsanleitung Seite 44

The pressure control dial (9) is set
too low.
Mesh filter handle (26), the spray tip
(5), or the suction hose mesh filter (13)
is clogged.
The paint pattern is
The suction hose (11) is loose at the
tailing.
suction hose inlet port (15).
The spray tip (5) is worn.
The paint is too thick.
44 | GB
Increase the pressure control dial (9) to a higher
setting.
Clean mesh filter handle (26), the spray tip (5), and
the suction hose mesh filter (13).
Re-adjust the suction hose (11) to the suction hose
inlet port (15) and use a flat head screwdriver to
tighten the screw on the metal hose clamp suction
hose inlet port (16).
Replace the spray tip (5).
Thin the paint according to the
manufacturer's instructions.
www.scheppach.com