Kessel Basic 400V Einbau- Und Betriebsanleitung Seite 30

Lay the connection cable securely (e.g. conduit pipe)
from the system tank to the control unit. Ensure that there
is adequate cable length for the maintenance of the elec-
trical components.
Attach ferrules (length 8 mm) to the cable ends.
Unscrew and remove housing cover.
Feed connection cable through suitable cable gland.
Fasten connection cable to the terminal strips in accor-
dance with connection diagram.
Fasten strain relief for all connection cables - tightening
torque 0.5 Nm.
Fit battery connector onto the battery.
Route the battery cable such that the LEDs are not cov-
ered or trapped.
Fit the housing cover and fasten in place - screw tighten-
ing torque 1.2 Nm.
30 / 120 Installation and operating instructions 016-306