Parkside PGSA 12 A1 Originalbetriebsanleitung Seite 25

14 Plug-in connector
15 Device housing
16 Plug
17 Socket
18 Adjusting screw, telescopic arm
19 Switch lock, telescopic arm
20 On/Off switch, telescopic arm
Technical data
Cordless
Combi-Shear ............... PGSA 12 A1
Motor voltage U .......................... 12 V
Rated speed n ...................... 1200 min
0
Sound power level (L
guaranteed ............................... 85 dB
Weight (incl. accessories) .. approx 1.66 kg
Grass-trimming blade
Cutting width ..........................120 mm
Sound pressure level
(L ) ....................72.7 dB, K
pA
Sound power level (L
measured ...... 80.7 dB; K
Vibration (a )
h
without telescopic
handle ............ 1.89 m/s
with telescopic
handle ............ 1.12 m/s
Shrub-trimming blade
Cutting length ........................170 mm
Cutting thickness ..............max. 7.9 mm
Sound pressure level
(L ) ....................69.4 dB, K
pA
Sound power level (L
measured ...... 80.4 dB; K
Vibration (a ) ... 2.02 m/s
h
The noise and vibration levels have been
calculated according to the norms stated in
the conformity statement.
(Direct voltage)
)
WA
= 3 dB
pA
)
WA
= 2.37 dB
WA
2
; K= 1.5 m/s
2 ; K= 1.5 m/s
= 3 dB
pA
)
WA
= 2.01 dB
WA
2
; K= 1.5 m/s
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
-1
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched off
and times when it is switched on but
running without any load).
Charging time
The device is part of the X 12 V TEAM
series from Parkside and can be operated
2
using batteries of the X 12 V TEAM series
from Parkside. Batteries of the X 12 V
2 TEAM series from Parkside may only be
charged using chargers of the X 12 V
TEAM series from Parkside.
We recommend that you operate this appli-
ance with the following batteries only:
PAPK 12 A3, PAPK 12 B3, PAPK 12 A4,
PAPK 12 B4, PAPK 12 C1, PAPK 12 D1.
2
We recommend charging these batteries
with the following chargers:
PLGK 12 A2, PLGK 12 B2, PDSLG 12 A1,
PDSLG 12 A2, PLGK 12 A3.
GB MT
25