Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Technical data
Cordless Planer .................PPHA 20-Li A1
Nominal voltage U ...................... 20 V
Idle speed n
....................... 14000 min
0
Protection category...........................IPX0
Weight ........................... approx. 2.1 kg
Cutting depth (10-stage) ............. 0 - 2 mm
optimal .............................. 0 - 1,2 mm
Rebate depth .......................max. 17 mm
Planer width ................................82 mm
Sound pressure level
) .....................84.4 dB(A), K
(L
pA
Sound power level (L
measured ...........95.4 dB(A); K
Vibration (a
) ...... 4.257 m/s
h
Temperature............................max 50 °C
Charging process ...................4 - 40 °C
Operation .......................... -20 - 50 °C
Storage .................................0 - 45 °C
Attention! An up-to-date list of
battery compatibility can be
found at: www.lidl.de/akku
This device can only be operated with
the following rechargeable batteries:
PAP 20 A1, PAP 20 A2, PAP 20 A3 ,
PAP 20 B1, PAP 20 B3.
This type of battery may only be charged
with the following chargers: PLG 20 A1,
PLG 20 A3, PLG 20 A4, PDSLG 20 A1.
PLG 20 A1
charging
PLG 20 A4
time (min.)
PAP 20 A1
PAP 20 B1
PAP 20 A2
PAP 20 A3
PAP 20 B3
Levels of noise and vibration were deter-
mined according to the norms and regula-
tions in the declaration of conformity.
= 3 dB
pA
)
WA
= 3 dB
WA
; K= 1.5 m/s
2
PLG 20 A3
PDSLG 20 A1
60
30
75
30
90
60
The vibration emission value has been mea-
sured according to a standardised testing
method and may be used for comparison
with another power tool.
The indicated vibration emission value may
-1
also be used for an introductory assessment
of the exposure.
Warning: The vibration emission
value whilst actually using the power
tool may vary from the given values
regardless of the type and way in
which the power tool is used.
Try to keep the exposure to vi-
brations as low as possible. An
2
example of a measure to reduce
vibration exposure is limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the power tool is switched off
and times when it is switched on
but running without any load).
Safety information
This section describes the basic safety rules
when working with the device.
Symbols used in the
instructions
Hazard symbol with infor-
mation on the prevention of
personal injury or property
damage.
Hazard symbol with information on
damage prevention.
Advisory symbol with information on
how to best use the device.
GB
IE
21
Werbung
