Renkforce WH2315 Bedienungsanleitung Seite 78

• Use the " " (3) or "
If the area with the time (upper left in the display) is selected, the lower text lines show "TIME ALARM" and
you can set the alarm time.
• Change the flashing value with the "
adjustment.
• To switch the alarm (or the alarm time) on or off, push the "SET" (5) button with the currently selected alarm.
When the alarm is activated, a bell icon " " is displayed at the lower right.
To leave the setting mode in any place, briefly push the button "HISTORY" (7). The settings made are
saved.
Alternatively, wait for 30 seconds without pushing a button. Setting mode is ended automatically in this
case.
• When an alarm is triggered (exceeding of a threshold at "HIGH ALARM", undercutting of a threshold at "LOW
ALARM" or at the alarm time), the basis station will emit a sound signal and the bell icon " " flashes. The cor-
responding text message appears at the bottom of the display.
• Push any button to end the sound signal. If the measured value remains above or below the set threshold, the bell
icon " " will continue to flash, however.
78
" (4) buttons to select the alarm you want to set. The respectively selected value flashes.
" (1) or " " (2) button. Keep the respective button pressed for quick