Renkforce WH2315 Bedienungsanleitung Seite 60

The enclosed metal tube has a small slot at one end. Plug the plastic Y-holder
right into this end, so that the plastic tab rests precisely in the slot of the metal
tube.
Then the plastic holder is fastened to the metal tube with a long screw (A) and
an M3 nut (C).
There is a small hole on one side of the metal tube as well. Turn the small screw
(D) in here for additional fastening.
Insert the rain sensor into the holder and fasten it to the
holder with the screw (E).
Then you can attach the holder to the metal tube as
illustrated (4 screws and nuts). Ensure that the rain sen-
sor is installed roughly at a 90°-angle to the holder of
the wind sensor.
The cable that comes out of the bottom of the rain sen-
sor should point in the direction of the metal tube.
60